One for All URC 7110 Essence TV - Manual (Page 69)

Press the key to which
the function will be
assigned (e.g. -/-- key).
Macro
3
Congratulations! You have successfully programmed a macro on the “-/--” key.
NOW, when you press the -/-- key:
1st: the TV will switch ON.
2nd: the TV will switch to EXT 1
3rd: the TV will switch to EXT 2.
The remote will do this in every device mode whenever you press the “-/--” key.
EXT 2
Command 1: TV ON
Command 2: AV (Ext.1)
Command 3: AV (Ext.2)
Press the -/-- key
You can program your ONE FOR ALL to issue a sequence of commands at the press of one single key. Any sequence of commands you regularly use can be reduced to one key press for
your convenience.
For example, you may want to create a macro that will switch ON your TV and then go dirtectly to
EXT 2 for your Playstation.
1st command: TV --> POWER (ON)
2nd command: AV --> EXT 1 (Digital Receiver Box)
3nd command: AV --> EXT 2 (Playstation)
To set up the Macro mentioned above on the e.g. “-/--” key on your ONE FOR ALL:
1
2
Press and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
Press 9 9 5. --> The blue LED will blink twice.
3
4
5
Co
m
m
an
d
1
Co
m
m
an
d
2
Co
m
m
an
d
3
How to reset the macro key to obtain its original function?
1) Press and hold magic for 3 seconds until a mode indicator (Blue LED)
stays lit.
2) Press 9 9 5.
3) Press the corresponding macro key (e.g. the -/-- key).
4) Press and hold magic key for 3 sec. --> The blue LED will blink twice.
Press the POWER key
x2
3 sec.
6
Press and hold magic for 3 seconds --> The blue LED will blink twice and then switch off.
3 sec.
Press the AV key twice (as you
would to go to EXT 2)
x2
Ext.1:
Digital
Receiver Box
Ext.2:
Playstation