Bissell PowerSteamer 8806 series - Manual (Page 8)

Flow indicator
This is located on the machine base. It spins
when the trigger is pressed to indicate that the
machine is applying cleaning solution to the
carpet and will stop spinning when the SmartMix
tank or Bladder needs to be refilled, or when the
trigger is released.
Note: Flow Indicator does not spin when
spraying through the attachment hose.
Ready tools dial
This provides either floor cleaning or above
the floor cleaning with the flip of a switch. If
choosing above floor cleaning for upholstery,
stairs, or along the baseboards, choose the
attachment appropriate for the job. Attach tool
to the hose, and you are ready to go!
1. Plan activities to give your carpet time to dry.
2. Move furniture to another area if cleaning an
entire room (optional).
3. Thoroughly vacuum area with a dry vacuum
cleaner before deep cleaning.
4. Plan your cleaning route to leave an exit path. It is
best to begin cleaning in the corner farthest from
your exit.
5. Pretreating (optional)
Note: Pretreating is recommended to improve
cleaning effectiveness for heavily soiled carpet in
high traffic areas such as entryways and hallways.
A. Spray the BISSELL Tough Stain Pre-treat formula
onto heavy traffic areas, soiled areas, or stains.
B. Allow to penetrate for at least 3 minutes.
C. Following the instructions below, clean as
normal, using the BISSELL PowerSteamer
machine on the high traffic setting.
O
peration
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition. Please see stain
removal instructions on page 14.
TOOLS
PRETREA
T
FLOOR CLEANIN
G
ON
OFF
Flow Indicator
TOOLS
PRETREA
T
FLOOR CLEANING
ReadyTools Dial
8
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
S
pecial Features of Your BISSELL PowerSteamer
2
4'
3'
1
3
4
5 6
7
9
10
11 12
EXIT
START
HERE
Pg 8
ug120-4080_7350_908.indd 8 10/14/08 1:28:02 PM