Multiquip MS1420E - Manual (Page 23)

TRAK-14 — OPERATION & PARTS MANUAL — REV. #2 (09/07/04) — PAGE 23
TRAK 14 — PRE-SETUP (ELECTRIC)
5. Plug the free end of the extension cord into an AC power
receptacle. Whenever possible use a GFCI receptacle
(Figure 14) to reduce the risk of electrical shock.
Figure 14. GFCI Receptacle
6. The TRAK-14 masonry saw is now ready for wet cutting . The
pre-setup procedures for electric models saws only is now
complete.
CAUTION CAUTION CAUTION CAUTION CAUTION
ALWAYS use a grounded (3-wire )
extension cord and MAKE CERTAIN that the
motor is connected to a properly grounded
electric circuit. If possible use a ground fault
circuit interrupter to protect the operator from
possible
electric shock .
Dry Cutting (Electric Saws Only)
1. Un-plug the water pump power cord from the outlet
receptacle on the electric motor conduit box.
NEVER dry cut with the pump connected
to a AC power source. Running the pump
dry will damage the pump. Always
disconnect the pump's power cord when
dry cutting.
CAUTION CAUTION CAUTION CAUTION CAUTION
2. The TRAK-14 masonry saw is now ready for dry cutting . The
pre-setup procedures for electric models saws only is now
complete.