Multiquip SP1E16A - Manual (Page 20)

page 20 — Sp1e16a paVeMeNT SaW • operaTioN MaNual — reV. #0 (04/14/10)
blaDeS/initial Startup
Cutting Depth adjustment
The saw is equipped with a Raise/Lower Assembly that is
supported by the following components.
„ Raise/Lower Acme Screw
„ Jack Arm
„ Blade Guard
„ Adjusting Handle Crank
iNiTial STarTup
1. Ensure the diamond blade has been mounted correctly
and that it is raised above the surface you are about to saw.
2. Use an extension cord (see Table 3) of adequate
current carrying capacity. Insert the electric motor’s
power plug into one end of the extension cord.
CauTioN
Do NoT attempt to operate the saw until the Safety,
General Information and Inspection sections of this
manual have been read and thoroughly understood.
See motor manufacturer's operating manual.
NeVer operate the saw in a confined
area or enclosed area structure that does
not provide ample free flow of air.
alWayS wear approved eye and hearing
protection before operating the saw.
NeVer place hands or feet inside the belt
guard or blade guard while the engine is
running. alWayS shut the engine down
before performing any kind of maintenance
service on the saw.
CauTioN
MaKe CerTaiN that the electric motor's power switch
is in the OFF position before plugging the motor into
the power source.
DaNger
NeVer use a worn or frayed extension cord.
NeVer operate saw with V-belt cover removed.
3. Plug the other end of the extension cord into a 230VAC
power source. Remember to read the nameplate to
determine the motor's input voltage requirement.
STarTiNg THe eleCTriC MoTor
1. Before starting, MaKe CerTaiN there is enough
clearance between the blade and the ground.
2. Set the electric motor’s ON/OFF switch (Figure 8) to
the ON position.
Figure 8. Electric Motor ON/OFF Switch
3. Before the saw is placed into operation, run the motor
for several minutes. Check for noises that would be
associated with loose guards and/or covers.
DaNger .
NeVer touch the power
cord with wet hands or while
standing in water when it is
connected to a power source.
The possibly exists of electrical
shock (electrocution) or even
death. NeVer spray water
directly on the electric motor.
WarNiNg
alWayS read the label on the electric motor before
applying power. The label will indicate the correct
power requirements for the motor. Remember, the use
of an incorrect input voltage will severely damage the
electric motor.
MaKe CerTaiN the motor is connected to a functional
ground fault circuit interrupter.
ON
OFF