Multiquip SP1CE13H18 - Manual (Page 24)

PAGE 24 — SP 1 SAW CE— OPERATION AND PARTS MANUAL — REV. #3 (06/09/08)
7. Grasp the starter grip (Figure 22) and slowly pull it out. The
resistance becomes the hardest at the compression point.
Pull the starter grip briskly and smoothly for starting.
Figure 22. Starter Grip
9. Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that could
be associated with loose guards and/or covers.
MQ STREET PRO 1 CE SAW — INITIAL START-UP
DO NOT pull the starter rope all the way to the end. DO NOT
release the starter rope after pulling. Allow it to rewind as
soon as possible.
6. Rotate the throttle lever (Figure 21) halfway between fast
and slow for starting. All sawing is done at full throttle . The
engine governor speed is factory set to ensure optimum
blade operating speeds.
Figure 21. Throttle Lever
8. If the engine has started, slowly return the choke lever
(Figure 21) to the "OPEN" position. If the engine has not
started repeat steps 1 through 7.
The engine speed has been set at the
factory. Changing the governor speed
could damage the blade and/or the saw.
5. Place the Choke Lever (Figure 20) in the " CLOSED "
position.
Figure 19. Engine Stop Switch (Handlebar)
The CLOSED position of the
choke lever enriches the fuel
mixture for starting a COLD engine.
The OPEN position provides the
correct fuel mixture for normal
operation after starting, and for
restarting a warm engine.
Figure 20. Choke Lever
NOTE
CAUTION
CAUTION