Multiquip CDM2CSA - Manual (Page 7)

DM15A9C/CDM2CSA — OPERATION AND PARTS MANUAL — REV. #1 (11/09/05) — PAGE 7
DM15A9C/CDM2CSA— RULES FOR SAFE OPERATION
The following safety guidelines should always be used when
operating the MQ
DM15A9C (electric motor) and CDM2SA
(drill rig)
GENERAL SAFETY
■ DO NOT operate or service this
equipment before reading entire manual.
■ This equipment should not be operated
by persons under 18 years of age.
■ NEVER operate this equipment without proper protective
clothing, shatterproof glasses, steel-toed boots, hard hat
and other protective devices required by the job.
■ NEVER operate this equipment under the influence of
drugs or alcohol.
■ NEVER operate this equipment when not feeling
well due to fatigue, illness or taking medicine.
■ NEVER operate the core drill in an
explosive atmosphere or near combustible
materials.The electric motor of this core-
drill emits sparks during operation and
shut-down. A explosion or fire could result
causing severe
bodily harm or even death if the sparks
make contact with combustibe or explosive materials.
■ Maintain this equipment in a safe operating condition at
all times.
■ Keep bystanders, children and vistors away while
operating the core drill. Distractions can cause you to
loose control.
■ DO NOT wear wear loose clothing or jewelry. Contain
long hair. Keep your hair, clothing, and gloves away from
moving parts.
■ ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children.
■ ALWAYS be sure the operator is familiar with proper
safety precautions and operation techniques before using
core drill.
■ ALWAYS keep work area clean and free of foreign matter
and debris. Also keep work area well lit.
■ Avoid accidental starting. Make sure power ON/OFF
switch is off before applying power.
■ NEVER leave the core drill unattended. When not in use
always unplug the core drill from power source.
■ ALWAYS remove any adjusting keys or wrenches before
turing the core drill on. A wrench or key that is left attached
to the rotating part of the core drill may result in personal
injury.
■ DO NOT overreach. Keep proper footing and balance at
all times. Proper footing and balance enables better
control of the core drill in unexpected situations.
■ Keep all inexperienced and unauthorized people away
from the equipment at all times.
■ Become familiar with the components of the core drill
before operating.
■ ALWAYS replace any worn or damaged warning decals.
■ NEVER touch drill bit cutting edges during operation. Also
allow drill bit a sufficient amount of time to cool before
touching.
■ ALWAYS wear proper respiratory (mask),
hearing and eye protection equipment when
operating the core drill.
■ Whenever necessary, replace nameplate, operation and
safety decals when they become difficult read.
■ Manufacturer does not assume responsibility for any
accident due to equipment modifications.
■ NEVER use accessories or attachments, which are not
recommended by Multiquip for this equipment. Damage
to the equipment and/or injury to user may result.
DANGER DANGER DANGER DANGER DANGER
Failure to follow instructions in this manual may lead to
serious injury or even death! This equipment is to be
operated by trained and qualified personnel only! This
equipment is for industrial use only.
Read this manual!