Sct series trowel — assembly and installation – Multiquip SCT46 User Manual
Page 19
SCT SERIES WALK-BEHIND TROWEL — PARTS & OPERATION MANUAL — REV. #4 (04/02/07) — PAGE 19
SCT SERIES TROWEL — ASSEMBLY AND INSTALLATION
Figure 11. Cable Yoke Attachment
5.
Using a wrench, tighten the second brass set nut up against
the yoke boss. This will lock the cable in place.
6.
Use a wrench and finish tightening the first brass set nut up
against the yoke boss.
2.
Remove one brass set nut from the blade pitch cable end
as shown in (Figure 10).
3.
Thread the second brass set nut towards the cable as far
as possible.
4.
Insert the cable end through the yoke eyelet (Figure 11)
Tighten the first brass set nut by hand to remove all the
slack from the cable.
Figure 10. Blade Pitch Cable
Safety Stop Wire
Locate the
SAFETY STOP
wire protruding from the handle tube
(Figure 8) and connect it to the
tail wire on the engine. Test the
safety stop switch to insure proper operation.
Figure 8. Engine Safety Stop Wire Connection
Figure 9. "No Pitch" Position
1.
Expose the pitch cable to maximum by adjusting the handle
pitch to the "no pitch" position. On the standard model turn
the pitch control counter-clockwise, (Figure 9).
Pitch Cable Installation
YOKE
THREAD CABLE END
THROUGH YOKE EYELET
TIGHTEN SECOND
BRASS SET NUT
AGAINST YOKE BOSS
USE A WRENCH TO
TIGHTEN FIRST BRASS
SET NUT AGAINST YOKE BOSS