Multiquip J-SERIES - Manual (Page 11)

J-SERIES WALK-BEHIND POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (09/30/10) — PAGE 11
J-SERIES TROWEL— RULES FOR SAFE OPERATION
■ DO NOT operate this trowel unless all guards and safety
devices are attached and in place. See Pages 16 and 17.
■ ALWAYS use proper lifting techniques when moving the
trowel.
■ ALWAYS check to make sure that the operating area is clear
before starting the engine.
■ ALWAYS test the safety
kill switch devices before operating
the trowel.
■ NEVER place your
feet or hands inside the guard rings
while starting or operating this equipment.
■ AVOID wearing jewelry or loose fitting clothing that may snag
on the controls or moving parts, this can cause a serious
injury.
■ ALWAYS keep clear of
rotating or moving parts while
operating the trowel.
■ NEVER leave the machine
unattended while running.
■ Moving Parts – Shut down the engine before performing
service or maintenance functions. Contact with moving parts
can cause serious injury.
Maintenance Safety
■ Disconnect the spark plug wires before attempting any type
of service.
■ Securely support any machine components that must be
raised.
■ NEVER lubricate components or attempt service on a running
machine.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
■ DO NOT pour
waste , oil or fuel directly onto the ground,
down a drain or into any water source.
CAUTION CAUTION CAUTION CAUTION CAUTION
Emergencies
■ ALWAYS know the location of the nearest
fire extinguisher and first aid kit . Know the
location of the nearest telephone. Also know
the phone numbers of the nearest
ambulance , doctor and fire department .
This information will be invaluable in the case
of an
emergency .
■ Keep the trowel in proper running condition.
■ Make sure that there is no buildup of concrete, grease, oil or
debris on the trowel.
■ Fix damage to the trowel immediately and always replace
broken parts.
■ Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil , fuel and fuel filters .
■ High Temperatures – Allow the machine and engine to
cool before adding fuel or performing service and
maintenance functions. Contact with hot! components can
cause serious burns.