Multiquip PSH - Manual (Page 17)

STOW PORTO-SCREED — OPERATION & PARTS MANUAL — REV. #1 (03/17/04) — PAGE 17
Figure 15. Throttle Lever (Run Position)
PORTO-SCREED PSH — INITIAL START-UP
Figure 14. Starter Grip
2. After the engine cools , turn the engine start/stop switch to the
“ OFF ” position (Figure 16).
Figure 16. Engine ON/OFF Switch (OFF Position)
3. Close the fuel shut- off valve (Figure 17) by moving the fuel
valve lever to the OFF position.
Figure 17. Fuel Valve Lever (OFF Position)
Stopping The Engine
1. Move the throttle lever to the IDLE or SLOW position (Figure
15) and run the engine for three minutes at low speed.
7. If the engine has started, slowly return the choke lever
(Figure 12) to the OPEN position. If the engine has not started
repeat steps 1 through 6.
8. Before the PSH is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose V-belt cover or component.
6. Grasp the starter grip (Figure 14) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.