Multiquip HAL 300 - Manual (Page 8)

PAGE 8 — Bullfloat HAL 150 & 300 — PARTS & OPERATION MANUAL — REV. #1 (05/27/99)
SAFETY INSTRUCTIONS
■
Connect the Bullfloat to an alternating voltage source of
115VAC, which is provided with a ground switch, with a
frequency of 60 Hz.
■
Check that the ventilation openings in the motor housing
are free from dirt and moisture.
■
Regularly check the connections of the feeder cable to
the switch.
Explanation of the utilized safety symbols.
1. Safety glasses, safety helmet and ear protection
compulsory.
2. Gloves compulsory.
3. Safety shoes with extra protection compulsory.
4. Dangerous electrical voltage.
5. Before opening the motor housing remove the plug.
6. Inflammable material.
7. Pls. read the operation-instructions
8. Careful, danger!
Tip: Ask the manufacturer for clarification, if you have any
questions about any of these safety instructions.
■
Check the feeder cable and extension cords outer casing
before you connect the Bullfloat to the electrical mains.
■
Check the feeder cable’s attachment on
the bullfloat, before you connect the Bullfloat
to the electrical mains. The cable must be
correctly attached to the Bullfloat.
■
Ensure that the feeder cable does not
graze past any sharp objects.
■
The use of extension cords are permitted, if they are
completely watertight.
■
Switch the Bullfloat “off” when the electrical
power cuts off.This prevents the Bullfloat from
starting suddenly when the electrical power
comes on again.
■
Check the feeder cable and extension cord’s attachments
regularly. When the Bullfloat is in operation, the plugs can
loosen due to the vibrations.
■
Disconnect the electrical supply to the Bullfloat, before you
start to clean or service the Bullfloat.
Important Safety Checks for the electrical Bullfloat