Accessories, Maintenance – Bosch 1594 User Manual

Page 14

-14-

Accessories

Service

Preventive maintenance
performed by unauthorized

personnel may result in misplacing of
internal wires and components which
could cause serious hazard.

recommend that all tool service be performed
by a Bosch Factory Service Center or Autho-
rized Bosch Service Station.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.

CARBON BRUSHES

The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.

BEARINGS

After about 300-400 hours of operation, or at
every second brush change, the bearings
should be replaced at Bosch Factory Service

Center or Authorized Bosch Service Station.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.

Cleaning

To avoid accidents always
disconnect the tool from

the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.

Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.

Certain cleaning agents
and solvents damage

plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.

Clean the park rest shoe regularly and ensure
that it springs back freely.

WARNING

Maintenance

CAUTION

If an extension cord is
necessary, a cord with

adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use
3-wire extension cords that have 3-prong
plugs and receptacles

NOTE: The smaller the gauge number, the

heavier the cord.

RECOMMENDED SIZES OF EXTENSION CORDS

120 VOLT ALTERNATING CURRENT TOOLS

WARNING

Tool’s

Ampere

Rating

Cord Size in A.W.G.

Wire Sizes in mm

3-6
6-8

8-10

10-12
12-16

0.75 0.75 1.5

2.5

0.75 1.0

2.5

4.0

0.75 1.0

2.5

4.0

1.0

2.5

4.0

—

100 150

120

Cord Length in Feet

Cord Length in Meters

Woodrazor reversible micro grain

TC blades (2) *

T-30 Torx blade wrench *

Deluxe Bevel Guide Fence *

Vacuum hose adapter **

Straight Guide Fence **

Rabbeting depth stop **

Chip bag *

High-Speed Steel Blades **

HSS Blade Leveling Fixture **

High-Speed Steel Blades with Retainers **

(*= standard equipment)

(**= optional accessories)