beautypg.com

C-30hdg pump — engine components – Multiquip C30HDG User Manual

Page 25

background image

MAYCO C-30HDG PUMP — OPERATION AND PARTS MANUAL — REV. #6 (04/02/12) — PAGE 25

C-30HDG PUMP — ENGINE COMPONENTS

Figure 9. Zenith 416 Basic Engine Components

Figure 9 illustrates the location of the basic components for the
Zenith 416, 1.6 liter gasoline engine..The function of each
component is described below:

1.

Air Filter – Prevents dirt and other debris from entering the
fuel system. Remove wing-nut on top of air filter cannister to
gain access to filter element. Replace with only
manufactures recommended type air filter.

2.

Fuse Connector – Contains fuses for electrical system.
replace with only recommended type fuses.

3.

Oil Filler Port Cap – Remove this cap to add engine oil to
the crankcase. Fill with recommended type oil as specified
in the maintenance section of this manual

4.

Spark Plug – Provides spark to the ignition system. Set
spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch). Clean
spark plug once a week

5.

Dipstick – Remove this dipstick to determine if engine oil
is low. Maintain oil level at the "H" marking on the dipstick.
NEVER run engine with low oil.

6.

Alternator – Provides power to the electrical system.
Replace with only manufactures recommended type
alternator.

7.

Oil Filter – Replace this oil filter as recommended in the
maintenance section of this manual.

8.

Fan V-Belt – ALWAYS make sure that V-belt is properly
tensioned. A loose or defective V-belt can adversely affect
the performance of the pump.

9.

Crankcase Drain Plug – Remove this plug to drain engine
oil from the crankcase. Replace with recommended engine
oil as specified in the maintenance section of this manual.

10. Cooling Fan Blades – Make sure that the blades of the

cooling fan are not

bent or broken

. A damaged fan blade

can cause the engine to run hot and overheat.

11. Control Relays – Includes a main relay, fuel pump relay

and starter relay. Replace with only recommended type
relays.

12. Starter Motor/Solenoid – NEVER

allow concrete or any

foreign debris to come in contact with the starter motor/
solenoid.

13. Fuel Filter/Fuel Pump/Fuel Regulator – Replace or clean

the fuel filter, fuel pump or fuel regulator as specified in the
maintenance section of this manual.

Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid
engine wear.