Multiquip WM45HCE_rev_0 - Manual (Page 17)

WM45HCe pLaSTeR MORTaR MIXeR • OpeRaTIOn and paRTS ManuaL — Rev. #0 (02/04/13) — page 17
initial start-up (enGine)
STOppIng THe engIne
normal Shutdown
1. Move the throttle lever to the IDLE position (Figure 14)
and run the engine for three minutes at low speed.
Figure 14. Throttle Lever (Idle)
2. After the engine cools, push the engine ON/OFF switch
inward to the “ OFF” position (Figure 15).
Figure 15. Engine ON/OFF Switch (OFF)
3. Place the fuel shut-off lever (Figure 16) in the " OFF"
position.
Figure 16. Fuel Valve Lever (OFF)
emergency Shutdown
1. Move the throttle lever quickly to the IdLe position, and
place the engine ON/OFF switch in the OFF position.
CauTIOn
aLWaYS run engine at full speed while mixing.
6. Grasp the starter grip (Figure 11) and slowly pull it out.
The resistance becomes the hardest at a certain
position, corresponding to the compression point. Pull
the starter grip briskly and smoothly for starting.
Figure 11. Starter Grip
7. If the choke lever was moved to the " CLOSed" position
to start the engine gradually move it to the "Open"
position (Figure 12) as the engine warms up. If the
engine has not started repeat steps 1 through 6.
Figure 12. Choke Lever (Open)
8. Before the mixer is placed in to operation, run the
engine for several minutes. Check for fuel leaks, and
noises that would associate with a lose component.
9. To begin mixing, place the throttle lever (Figure 13) in
the “ Run” position .
Figure 13. Throttle Lever (Run)