Multiquip MTR60L - Manual (Page 11)

MTR-60L — PARTS & OPERATION MANUAL — REV. #7 (06/26/01) — PAGE 11
MTR-60L — CONTROLS AND COMPONENTS
Figure 1. MTR-60L Tamping Rammer
Figure 1 shows the location of the controls and components
for the MTR-60L Tamping Rammer. The functions of each
control is described below:
1. Fuel Tank/Cap – Remove this cap to add fuel. Tank holds
.39 gallons (1.5 liters ) unleaded. Mix 32:1 ratio with
outboard motor oil.
2. Throttle Lever – Controls engine speed and the tamping
action of the rammer.
3. Handle – To operate rammer GRIP handle assembly
firmly.
4. Fuel Shut-Off Valve – Supplies fuel from the fuel tank to
the engine. To begin fuel flow move the fuel shut-off valve
downward.
5. Choke Lever – Used when starting the engine. Normally
used in cold weather conditions. In cold weather turn the
choke lever to the fully closed position, in warm weather
set choke lever half way or completely open.
6. Engine Air Cleaner – Prevents dirt and other debris
from entering the engine.
7. Grease Fill Plugs – Grease these plugs to lubricate the
top and bottom mechanical component ends of the
rammer.
8. Foot – Laminated wood with tempered steel plate for
superior shock absorption.
9. Fuel Valve – Open this valve to remove excess fuel from
the carburetor or crankcase.
10. Nameplate – Displays information regarding the rammer.
11. Muffler– Used to reduce noise and emissions.
12. Recoil Starting Handle – Used when starting the engine.
Pull starter handle sharply and quickly, then return
starter handle to starter case before releasing.
13. Engine Stop Switch – Controls the starting and stopping
of the engine. Switch must be in the "ON" position when
starting the engine.
14. Spark Plug – Provides spark to the ignition system,
replace with engine manufactures recommended type
spark plug.