Mtr-40hs— initial start-up, Caution – Multiquip MTR40HS User Manual

Page 16

PAGE 16 — MTR-40HS— PARTS & OPERATION MANUAL — REV. #2 (12/15/03)

MTR-40HS— INITIAL START-UP

Figure 6. Fuel Shut-Off Valve (Open)

Set the engine ON/OFF switch (Figure 7) to the "ON"
position (start).

Figure 7. ON/OFF Switch (ON Position)

3. Move the throttle lever to the "IDLE" position (Figure 8).

Figure 9. Choke Lever (Closed)

Figure 8. Throttle Lever (Idle)

4. In cold weather, start the unit with choke lever "Fully Closed"

(Figure 9). In warm weather or when the engine is warm, the
unit can be started with choke halfway or completely open.

This section is intended to assist the
operator with the

initial start-up

of the

MTR-40HS

rammer. It is extremely

important that this section be

read

carefully

before attempting to use the

rammer in the field.

DO NOT use your rammer until this section is thoroughly
understood.

CAUTION:

Failure to understand the

initial start-up

procedures

of the MTR-40HS rammer could

result in severe damage to the rammer or
personal injury.

See Figure 1 (Page 13) for the location of any control referenced
in this manual.

Initial Start-up

The following steps outline the procedure for starting the engine:

Open the

fuel shut- off valve

by moving the

fuel cock

lever to the

open

position (Figure 6).