Caution, Mt-62hs — initial start-up – Multiquip MT62HS User Manual

Page 16

PAGE 16 — MT-62HS — PARTS & OPERATION MANUAL — REV. #2 (12/15/03)

3. Move the

throttle lever

to the "IDLE" position (Figure 8).

Figure 9. Choke Lever (Closed)

Figure 8. Throttle Lever (Idle)

4. In cold weather, start the rammer with the

choke lever

in the

"Fully Closed" position (Figure 9). In warm weather or
when the engine is warm, the unit can be started with choke
halfway or completely open.

Figure 6. Fuel Shut-Off Valve (Open)

This section is intended to assist the
operator with the

initial start-up

of the

MT-62HS

rammer. It is extremely

important that this section be

read

carefully

before attempting to use the

rammer in the field.

DO NOT use your rammer until this section is thoroughly
understood.

CAUTION:

Failure to understand the

initial start-up

procedures

of the

MT-62HS

rammer could

result in severe damage to the rammer or
personal injury.

See Figure 1 (Page 13) for the location of any control referenced
in this manual.

Initial Start-up

The following steps outline the procedure for starting the engine:

Open the

fuel shut- off valve

by moving the

fuel cock

lever to the

open

position (Figure 6).

Turn the engine

ON/OFF

switch (Figure 7) to the

"ON"

position.

Figure 7. Engine ON/OFF Switch

MT-62HS — INITIAL START-UP