Multiquip MT86D2 - Manual (Page 9)

MT-86D2 TAMPING RAMMER— OPERATION AND PARTS MANUAL — REV. #3 (06/18/07) — PAGE 9
■ ALWAYS stop the engine before servicing, adding fuel and
oil.
■ NEVER run engine without air filter. Severe engine may
occur.
■ ALWAYS service air cleaner frequently to prevent carburetor
malfunction.
■ ALWAYS check the machine for loosened threads or bolts
before starting.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using rammer.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of
the reach of children.
■ DO NOT operate this equipment unless all guards and
safety devices are attached and in place.
■ CAUTION must be exercised while servicing this equipment.
Rotating and moving parts can cause injury if contacted.
■ Keep all inexperienced and unauthorized people away
from the equipment at all times.
■ Unauthorized equipment modifications will void all
warranties.
■ NEVER pour or spray water over the engine.
■ Test the engine ON/OFF switch before operating. The
purpose of this switch is to shut down the engine of the
rammer.
■ Refer to the Yanmar Engine Owner's Manual for engine
technical questions or information recommended by
Multiquip for this equipment.
TRANSPORTING
■ ALWAYS shutdown engine before transporting.
■ Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
■ Drain fuel when transporting rammer over long distances
or bad roads.
■ When placing the rammer inside a truck-bed for transport,
always tie-down the rammer
MAINTENANCE
■ NEVER lubricate components or attempt service on a
running rammer.
■ ALWAYS allow the rammer a proper amount of time to
cool before servicing.
■ Keep the rammer in proper running condition.
■ Fix damage to the rammer immediately and always
replace broken parts.
■ Dispose of hazardous waste properly. Examples of
potentially hazardous waste are used motor oil, fuel
and fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
MT-86D2 TAMPING RAMMER — RULES FOR SAFE OPERATION
■ In emergencies always know the location of
the nearest phone or keep a phone on the job
site. Also know the phone numbers of the
nearest
ambulance, doctor and fire
department. This information will be invaluable
in the case of an emergency.
EMERGENCIES
■ ALWAYS know the location of the nearest fire
extinguisher and first aid kit.