Multiquip MT86D2 - Manual (Page 15)

MT-86D2 TAMPING RAMMER— OPERATION AND PARTS MANUAL — REV. #3 (06/18/07) — PAGE 15
Rammer Gearbox and Spring Cylinder
This unit uses an oil bath lubrication system. Check oil level
through oil level sight glass at rear of tamper foot. If oil is not
visible, add #10W-30 motor oil. Oil bath contains approx. 1.7 pt.
(800cc).
Engine
1. Fill the fuel tank with automobile diesel fuel (See Figure 3).
2. For checking the oil level, move the engine to vertical
position and check that the oil is level with the oil inlet (about
700cc). See Figure 4.
MT-86D2 TAMPING RAMMER — INITIAL START-UP
This section is intended to assist the operator with the initial
start-up of the MT-86D2 Tamping Rammer. It extremely important
that this section be read carefully before attempting to operate
the rammer.
DO NOT use your rammer until this section is thoroughly
understood.
CAUTI CAUTI CAUTI CAUTI CAUTION
Failure to understand the operation of
the MT-76D2Tamping Rammer could
result in severe damage to the rammer
or cause personal injury.
Read Manual
Figure 3. Fuel Tank
INSPECTION
1. Check all nuts, bolts and fasteners for tightness. Retighten
as necessary.
2. Clean dirt from the recoil starter and foot. Wipe entire unit
clean before operating.
3. Replace any missing or damaged Safety/Operation decals.
Figure 4. Oil Level