Multiquip MT86D2 - Manual (Page 19)

MT-86D2 TAMPING RAMMER— OPERATION AND PARTS MANUAL — REV. #3 (06/18/07) — PAGE 19
MT-86D2 TAMPING RAMMER — MAINTENANCE
Cleaning the Air Cleaner
Clean the Air Cleaner every 200-300 hours. See Figure 11.
■ Remove element from pre-cleaner at the top of crankcase
(body side).
■ Wash the element (outside) in detergent solution.
■ Shake out excess moisture and dry the element.
■ Clean inside element with air from the inside of element.
Cleaning the Oil Filter
Drain oil filter every 100 hours of operation. Replace the oil filter
every 1,000 hours of operation. See Figure 12.
Figure 11. Air Cleaner
Fuel Pipe & Oil Pipe
■ Check fuel line regularly for damage, paying attention to
clamps to assure a tight fit.
■ Replace fuel line every two years to maintain original
performance.
Transportation
Maintain upright position of rammer at all times. Transport rammer
in upright position. If machine must be laid down for
transportation, drain the diesel fuel first and lay machine with
muffler side down. See Figure 13.
The fuel filter is installed at the bottom of fuel tank. Should the
rammer be laid on its side, dirt from the fuel filter may contaminate
the injection nozzle, causing damage to the fuel pump.
Storage
■ When storing the rammer for long periods of time, thoroughly
drain all fuel from line.
■ Clean exterior of rammer with an oil moistened cloth. Cover
and store in a clean, dry place.
Figure 12. Oil Filter
Figure 13. Transporting Rammer