beautypg.com

Bunn U3A User Manual

Page 23

background image

Page 23

SERVICE (cont.)
START SWITCH (BREW)

FIG. 20 START SWITCH (BREW)

P2104.25

Location:

The brew start switch is located on the upper right

side of the brewer component housing.

Test Procedures:
1. Disconnect the brewer from the power source.
2. Remove the wires from the start switch terminals.
3. Check for continuity across the switch terminals

when the switch is held in the lower position.
Continuity must not be present when the switch is
in the upper position.

If continuity is present as described, reconnect the
wires the switch is operating properly.

If continuity is not present as described, replace the
switch.

BLU to Brew Timer

RED from ON/OFF
Switch

FIG.21 BREW START SWITCH TERMINALS

P2111

Removal and Replacement:
1. Remove the wires from the switch terminals.
2. Compress the clips on the back side of the switch

mounting bracket and gently push them through
the opening.

3. Push the new switch into the opening and spread

the clips to hold switch in the mounting bracket.

4. Refer to Fig. 21 and reconnect the wires.

10060.3 070102