Setup, adjustment & operation – MK Diamond MK-112 User Manual
Page 16

16
SETUP, ADJUSTMENT & OPERATION
ADJUSTMENT & OPERATION
1. Cutting at 90°:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
In order to make any diagonal cuts, position the tile against the cutting guide as shown in PICTURE 8.
PICTURE 8
Thanks to the great versatility of the MK-112 Saw it is possible to carry out different types of cuts.
Take the blade to the 0° position with the angle adjustment knobs (See PICTURE 6). Position the tile on the
support table and make sure that it is properly positioned against the cutting guide.
THE RULER PLACED ON THE WORKING TABLE HELPS ONLY WITH RIP CUTTING
PICTURE 6
PICTURE 7
Angle Adjustment Knob
CAUTION
CAUTION
See also other documents in the category MK Diamond Power saws:
- MK-770 (41 pages)
- MK-770 EXP (46 pages)
- MK-660 (44 pages)
- MK-470 (12 pages)
- MK-377 (36 pages)
- MK-370 (36 pages)
- MK-370 EXP (52 pages)
- MK-170 (36 pages)
- MK-145 (32 pages)
- MK-145 220 Volt (32 pages)
- MK-101 (52 pages)
- MK-101 (56 pages)
- MK-101-24 (52 pages)
- MK-101-24 (56 pages)
- MK-101 Pro / Pro24 (56 pages)
- MK-101 Tracker (45 pages)
- MK-101Pro24 JCS (60 pages)
- MK-101 JCS Rental (51 pages)
- MK-101 Lowes (56 pages)
- MK-101 Lowes (52 pages)
- MK-100 (44 pages)
- MK-100 (52 pages)
- MK-100 Tracker (46 pages)
- MK-100 JCS (49 pages)
- TX-3 (52 pages)
- Saw Tent (2 pages)
- MK-1070 (22 pages)
- MK-212 (52 pages)
- MK-1590 (36 pages)
- MKDX Profile Milling Machine (40 pages)
- MK-EZ Profile Milling Machine (36 pages)
- MK-1503SS (24 pages)
- MK-1080 (44 pages)
- MK-1080 (1 page)
- MK-1080 (3 pages)
- MK-1280 Gas Saw (48 pages)
- MK-1280 Electric Saw (40 pages)
- MK-1280 Rolling Cart (4 pages)
- MK-1270 (Shindaiwa) (28 pages)
- MK-2000 Electric Saws (52 pages)
- MK-2000 Gas (60 pages)
- MK-5005S (56 pages)
- MK-5000 Gas Saws (56 pages)
- BX-3 (36 pages)