MK Diamond MK-145 - Manual (Page 16)

16
MK-145 SETUP
Overfilling the Water Basin can lead to water entering the motor compartment and potential electric shock.
If an extension cord is used, first verify it meets the requirements of TABLE 1 (Page 9). Plug the
MK-145 into the extension cord, plug the extension cord into a GFCI and finally, plug the GFCI into
the power source in that order.
(D)
Fill the Water Basin up to
the mark indicated on the
Water Level Label
(E)
Verify the Water Basin
water level, is below the
Upper Limit Indicator Arrow
(F)
Insert the three (3) Cover
Retaining Tabs into the three
(3) Cover Alignment Slots
and seat the Water Basin
Cover on the MK-145
(C)
Lift Water Basin Cover,
Pull out on Water Basin
Cover to remove
(C)
Lift Water Basin Cover,
Pull out on Water Basin
Cover to remove
WARNING
WARNING
(G)
Verify the ON/OFF Switch
is in the OFF position
(H)
Plug the MK-145 into
a GFCI
(I)
Plug the GFCI into the
power source