Mk-377 saw troubleshooting – MK Diamond MK-377 User Manual

Page 26

"Rodding" cooling channels is performed by inserting a small wire rod through the cooling

inlet on top of the Blade Guard and directing the rod out through each of the cooling

flow tubes located on the underside of the Blade Guard. The cooling channels should be

"rodded" until all ports are free of foreign debris.

NOTE:

(D)

Remove the Blade Guard Intake

Fitting

(E)

Clean the Blade Guard Intake

Fitting

(F)

Locate the Blade Guard Cooling

Channels

(G)

Rod Cooling Channels and

recheck flow

MOVABLE CUTTING TABLE DOES NOT MOVE CORRECTLY

(A)

Check the Guide Bar and Roller

Wheel Guide Frame is clean -

clean if dirty

(B)

Check the Movable Cutting

Table Roller Wheels for wear

replace if necessary

MK-377 SAW TROUBLESHOOTING