Meade Instruments TE346W - Manual (Page 8)

BATTERY INSTALLATION
• Remove the battery door located at the back of the main unit.
• Insert two (2) CR2032 lithium cell batteries and replace the battery compartment door.
PLACEMENT
• When mounting the main unit on the wall or vertical surface, fold the table stand back into
the unit.
• Make sure that the main unit is locating within the operating range of all remote sensors.
• Ideally the main unit should be placed within line of sight of remote sensors. Avoid placing
the main unit where surfaces emitting and radiating heat (e.g. heating ducts or air
conditioners) and areas with interference from wireless devices (e.g. cordless phones, radio
headsets, baby monitoring devices and other electronics).
OPERATION
Once the main unit is powered, the display will show all available LCD segments for a moment.
GETTING STARTED
WEATHER FORECAST
This unit is capable of detecting the atmospheric pressure changes. Based on collected weather
data, it forecasts the weather for the next 12 to 24 hours.
When the
display
shows...
Forecast
is... Sunny
Partly
Cloudy
Heavy
Rain
Heavy
Snow
Cloudy Rainy Snowy
NOTE: The weather forecast accuracy is approximately 70%.
The main unit display shows forecasted (predicted) not current conditions. The SUNNY
icon indicates clear weather, even when displayed during the nighttime.
TEMPERATURE/ HUMIDITY WINDOW
The main unit supports up to 3 remote sensors, corresponding to a separate channel of the
temperature display and it can be formatted in Celsius (ºC) or Fahrenheit (ºF).
The main unit carries the humidity sensor and uses this data to calculate an indoors comfort
level - Wet, Comfort or Dry.
A temperature alert function is available for all channels. It can be programmed to sound if the
channel temperature exceeds or falls below the pre-set upper and lower limits.
REMOTE SENSORS STATUS
The wave icon next to the current channel icon shows the connection status of the
corresponding remote sensor:
Icon Status
Searching for the signals from the remote sensor
Corresponding remote sensor signal received
successfully
No signals received for over 1 hour
8