Meade Instruments TE346W - Manual (Page 11)

• The atomic clock receiver is programmed that it will search for the time signal daily for 0:00,
3:00, 6:00, and 12:00 am.
• To enable or disable the atomic time receiver, press and hold UP (? ) button for 3 seconds.
If time reception is activated, a tower icon will start flashing. If reception is disabled, the
tower icon will disappear.
• If the time signal has not been received in 8 minutes, you may set the time manually.
MANUAL SETTINGS
To select the time mode, press UP (? ) or DOWN (? ) until the IN icon flashes with a beep
sound alert. It is necessary to set the desired US TIME ZONE.
TIME ZONE
• Press MODE button once to select hour and minutes with the day of the week display.
• Select the Time Zone by pressing and holding UP (? ) button for 3 seconds
• Keep holding UP (? ) button until the desired US Time Zone (Pacific, Mountain, Central or
Eastern) is highlighted on the display’s US map, located to the right of the time display and
above the day of the week
• Release the UP (? ) button. The Time Zone is set.
TIME AND CALENDER
• Press and hold MODE button until the day of week language abbreviation “ENG” will flash
• Press the UP (? ) or DOWN (? ) selecting the day of the week in English, German, French,
Italian, Spanish, Dutch or Swedish.
• After the language of weekday is set, press MODE button to confirm and move to the next
parameter (year)
• Continue setting the year, month, day, time format (12 or 24 hours), local hour and minutes,
using the same technique
• After programming is complete the display will return to the default hour and minutes with
seconds display.
CLOCK ALARMS
There are two time alarms – Weekday alarm (W) and Single day alarm(S) - and one Ice
Warning Alarm (PRE-AL).
• If Weekday (W) alarm is activated, it will sound at the set time and the alarm icon will flash
Mondays through Fridays
• If Single (S) day alarm is activated, it will sound at the set time and the alarm icon will flash
only for this specific day and will not activate on subsequent days
• If Ice Warning Alarm ( PRE-AL) is activated, in will sound at the set time and alarm icon
will flash once the remote temperature for Channel One (1) will reach 32°F(0°C) and below
NOTE: Ice Warning Alarm can be set only if one or both - Weekday or Single alarm - are
programmed.
SETTING THE WEEKDAY (W) AND SINGLE DAY (S) ALARMS
• Press ALARM button once to enter into the alarms setting mode. The default alarm is a
Weekday alarm (W). The abbreviation “OFF” with a letter “W” next to it will be displayed,
if the alarm has not been set previously
• Press and hold ALARM button for two seconds. The hour digit will flash
• Adjust the hour using UP ( ? ) or DOWN ( ? ) buttons
• Press ALARM button again. The minute digits will flash
• Adjust the minutes using UP (? ) or DOWN (? ) buttons
• Press ALARM button again to confirm and the weekday alarm time will be set
• Set Single (S) day alarm if desired in the same manner
11