Connecting a composite video source device – BenQ CP220 User Manual
Page 26
Connection
20
Connecting a composite Video source device
Examine your Video source device to determine if it has a set of unused composite Video
output sockets available:
•
If so, you can continue with this procedure.
•
If not, you will need to reassess which method you can use to connect to the device.
To connect the projector to an composite Video source device:
1.
Take the (optional accessory) Video cable and connect one end to the composite Video
output socket of the Video source device.
2.
Connect the other end of the Video cable to the VIDEO socket on the projector.
3.
If you wish to make use of the projector (mixed mono) speaker, take a suitable audio
cable and connect one end of the cable to the audio output sockets of the video device,
and the other end to the AUDIO socket of the projector.
Once connected, the audio can be controlled by the projector volume and mute
settings. See
for details.
The final connection path should be like that shown in the following diagram:
•
The projector is only capable of playing mixed mono audio, even if a stereo audio input
is connected. See
for details.
•
If the selected video image is not displayed after the projector is turned on and the
correct video source has been selected, check that the Video source device is turned on
and operating correctly. Also check that the signal cables have been connected
correctly.
•
You need only connect to this device using a composite Video connection if Component
Video and S-Video inputs are unavailable for use. See
for details.
A/V device
Video cable
Audio cable