MBT Lighting LZ600RG - Manual (Page 4)

4
237～255 Sound Red/Green
CH2 MOTOR
0～4 Motor Stop
5～125 Right Rotate (slow —medium--fast)
126～131 Motor Stop
132～249 Left Rotate (slow —medium--fast)
250～255 Motor Sound
CH3 Red Strobe 0～4 No Strobe
5～255 Slow to Fast
CH4 Green Strobe 0～4 No Strobe
5～255 Slow to Fast
NOTES: WHEN CH1IS IN AUTO OR SOUND MODE (FROM 92 TO 255), CH2, CH3, CH4 HAVE NO EFFECT
AT THE SAME TIME.
General Operation:
1. Mode settings: Based on different application, different modes are set. If in DMX mode, bear in
mind the correct DMX address assignment.
2. Connection: connect the projector and DMX 512 console with the DMX signal cable. As for
Stand Alone, there is no need.
3. Powered on, laser emits the beam in 1 second.
4. The projector can be controlled to play and edit shows by DMX512 console in DMX mode, by
default program in auto mode, and in sound active mode if sound sensitivity knob is kept in
proper position.
5. There is no MASTER/SLAVE Mode for this laser projector.
Auto / Sound Active Mode:
1. Auto/Sound Active——Via SOUND_ACTIVE or AUTO, no console is needed. Laser shows only
obey sound or default program.
2. Mode settings: set the dipswitch in corresponding position, that is
SOUND_ACTIVE：＃1－0，＃10－0
AUTO： ＃1－1，＃10－0
(NOTE: PLEASE SET #2～#9 ACCORDINGLY.)
3. Powered on, laser emits the beam in 1 second.
4.The projector is able to play different default programs in Auto mode by setting dipswitches #2～
#9 , and in SOUND_ACTIVE mode it needs to adjust sound sensitivity knob to proper position
first.