Mayline Four Post Shelving - Manual (Page 4)

FRONT
FRONT
When a Pull-Out Reference Shelf is used,
Set each reference shelf end bracket assembly into
slots in upright.
Using the holes in the bracket as pilot holes, drill 2
holes (1/4" diameter) into the upright. Secure the
bracket to the upright with 1/4-20 x 1/2 screw and
nut. Do both brackets.
BACK PANEL or CENTER PANEL INSTALLATION
Rest the panel flange on top of the 4-Post assembly
and center the panel side to side. Peal away
protective film from tape on inside of panel and press
firmly into position.
Optional: Attach the panel using (4) #10 TEK
self-drilling screws. Located at the top flange into top
shelf and along the bottom into the bottom shelf. A
power driver must be used to thread the screws into
the uprights.
UNDERSIDE of
Sliding Shelf shown
These screws
are optional
These screws
are optional