Mayline Dual Adder - Manual (Page 4)

NOTE: If installing a table without access panels (6),
proceed to Step 7.
6. Attach mounting angles (E12) to beam assembly (2)
using screws (E13). Align with angles on trough sides.
7. Install beam (2) from above. Place beam (2) between
legs (1) by tipping the beam (2) into the leg flange notch .
Secure beam (2) with screws (E3) and washers (E4).
Tighten all screws (E3) at this time.
8. Insert bushings (E9) into trough sides (3).
9. Lay pan (4) onto trough side flanges (3). Secure pan (4)
to trough sides (3) using pine tree clips (E11)
10. Install slam latch (E8) into slot in inner leg panel (7) as
shown.
11. Insert tabs in the bottom of inner leg panel (7) into slots
in foot. Rotate inner leg panel (7) up so that slam latch
catches flange on pan (4).
12. Insert square hole plugs (E7) and pine tree clips (E10)
into holes in beam. NOTE: This step should be done after
privacy panels or monitor posts are installed in the beam.