beautypg.com

Mayline Dual Adder User Manual

Page 3

background image

4. Install screws (E3) to the inside of leg (the side opposite gusset
flange), leaving approximately 1/8" between screw head and leg tube.
5. Using slots in trough sides (3), hook trough sides onto screw

heads on both legs. DO NOT TIGHTEN SCREWS.

1. Install tube inserts (E1) into leg (1).

2. Screw glide (E2) into inserts.

NOTE: If the desired configuration utilizes multiple adders, substitute

an adder leg for the right hand starter leg shown in the following
steps.

NOTE: The illustrations shown here reflect a 60"W or
72"W table. If installing a 48"W, part quantities may

vary.

NOTE: If installing a table without access panels (6),
proceed to Step 4.

3. Attach mounting angles (E12) to trough side (3)
using screws (E13).

48" Trough side

72" & 60" Trough sides