Mayline Dual Starter - Manual (Page 5)

Install dowels (E13) in
underside of access panels
10. Lay pan (4) onto trough side flanges (3). Secure
pan (4) to trough sides (3) using pine tree clips (E10).
11. Install slam latch (E7) into inner leg panel slot (8)
as shown.
12. Insert tabs in the bottom of inner leg panel (8) into
slots in foot. Rotate inner leg panel (8) up so that slam
latch catches flange on pan (4).
13. Install outside leg panels (7) by aligning the one
flange with the inside edge of the tube and applying
pressure to create a curve in the end panel that allows
2nd flange to slide inside edge of tube.
14. Insert square hole plugs (E6) and ratchet fastener
(E9) into holes in beam (2). NOTE: This step should be
done after privacy panels or monitor posts are installed in
the beam.
For tables "WITHOUT" Access Panels (6).
15. Position work surface (5) without access
panels and secure with screws (E5).
For tables "WITH" Access Panels (6).
15. Insert dowels (E13) into holes in access
panels (6) as shown below. NOTE: For 48" W
tables use the positions shown in the far left and
right of the view below.
16. Lay access panels (6) onto table frame
so that dowels engage holes in mounting angle..
17. Insert spacers (E14) between access
panels and work surfaces as shown (2 per
access panel).
18. Position work surfaces and secure with
screws (E5). Remove spacers.