Mayline Forester Wood 4-Post Table - Manual (Page 4)

1. Mark the position for the Rubber Bumpers
(E11) on the top at the locations shown.
2. Thread Screw (E10) through the Bumper
(E11). Place the point of the screw at the mark
and tighten the bumper into position.
INSTALLATION INSTRUCTIONS
for 8187 Light Box to Forester Table
1 1/2"
1"
1 1/2"
1"
3. Position the Light Box over the Forester
worksurface with the Light Box Rod beyond
the end of the top and the pull toward the
front of the base.
Place the Light Box Rod down so that it
will be located under the worksurface. Slide
the Light Top forward till it touches the
bumpers.
(4)