Handle installation – MARVEL Scientific 25CM User Manual
Page 5

Figure 3
• Do not splash or spray water from a hose on the ice ma-
chine! Doing so may cause an electrical shock, which may
result in severe injury or death.
• This unit should not, under any circumstances, be installed
to an un-grounded electrical supply.
Grounding Method
This product is factory equipped with a power supply cord that
has a three-pronged, grounded plug. It must be plugged into a
mating grounding type receptacle in accordance with the Na-
tional Electrical Code and applicable local codes and ordinances
(see Figure 3). If the circuit does not have a grounding type re-
ceptacle, it is the responsibility and obligation of the customer to
provide the proper power supply. The third ground prong should
not, under any circumstances, be cut or removed.
Electrical Connection
A 115 volt, 15 amp dedicated circuit is required. A 3 prong
grounded receptacle is required.
The unit must be installed according to your local building codes
and ordinances.
Do not use an extension cord with
this appliance.
HANDLE INSTALLATION
Handle Installation (Solid Door Models)
1. Remove the handle, (2) screws, and 5/32” allen wrench from
the bag shipped inside the cabinet.
2. Locate handle opposite the hinges and secure in place using
the (2) screws and the allen wrench. (See Figure 4).
Screws
Handle
Figure 4
Right hand hinged
door shown
Door Reversal
It is possible to reverse the door (change from right hand swing
to left hand swing or vice versa) if you wish. To do so it will be
necessary to order one of the service kits below.
Hinge Color
Door Color
Right Hand
Left Hand
Chrome
Black
42247595
42247599
Chrome
White
42247639
42247640
Black
Black
42247596
42247600
White
White
42247597
42247601
Stainless
Steel
Stainless
Steel
42247598
42247602
5