Marshalltown 46E11 Cyclone Power Trowels - Manual (Page 15)

2A-1
Step 1
Step 2
Step 3
STEP 1: Un-pack the handle assembly(A) and the
lower unit from their boxes. Check to make sure no
damage was done during shipment. Mount the handle
assembly(A) to the gearbox(B) on the lower unit using 4
3/8" nylock nuts(C) that are supplied in a package on the
lower unit.
A
C
STEP 2: With the handle mounted to the lower unit, attach
the pitch control cable(A) through the yoke arm(B) using
the remaining 3/8" nylock nut(C). Tighten the nylock nut
to where there is approximately a 1/4" of the threads are
showing.
STEP 3: Attach the kill wire(A) that is coming from the
handle assembly to the engine using the wire splicer(B)
that is supplied on the lower unit.
C
B
B
ASSEMBLY INSTRUCTIONS
B
A
A
Step 4
STEP 4: Make sure that the throttle lever on the handle
assembly is pushed all the way forward. Remove the
breather cap and the breather from the engine. Unscrew
the cable adjustment clasp(A). Next, make sure that
the throttle lever(B) on the engine is pushed all the way
forward. Insert the wire coming out of the cable into the
hole(C) shown on the diagram. With everything in place,
put the cable adjustment clasp(A) back on and tighten
down snug.
A
B
C
2A
ASSEMBLY