Buffalo Technology WLA2-G54 - Manual (Page 2)

2
Deciding on a Mode for Initial AirStation Configuration
Ạ Wired Connection (recommended)
ạ Wireless Connection
Do not connect the AirStation to your existing network
until configuration of the AirStation is complete!
Step Ẅ
Connect your computer to the AirStation
Buffalo recommends using a wired connection, meaning your computer is physically
connected to the
AirStation with an CAT5 cable plugged into the LAN port. This
type of setup will eliminate possible setup problems due to any issues with the wire-
less adapter on the computer being used to configure the
AirStation.
A Web browser version 4.5 or later should be used to configure the
AirStation.
Using the provided CAT5 Ethernet Cable, connect one end to the 10/100Mbps
port on the AirStation and the other to your computers available Ethernet port.
Figure shown above.
Ạ ạ
Ạ Wired Configuration