Belkin USB Ethernet Adapter F5U011 User Manual

Page 12

You replaced the Ethernet Adapter with a new
Ethernet Adapter and it does not work.

The installation procedure produces the
message: Hardware and software support for
USB was not found.

The LED is off.

The LED is blinking.

You require additional information about
adding or removing network drivers.

The system does not respond when connecting
the Adapter (for example, the hourglass cursor
remains on the screen).

Each Belkin USB Ethernet Adapter has a

unique encoded Ethernet identifier. Unplugging

the adapter from the Windows

machine, and

plugging a different adapter into the same port,

will cause a problem in the protocol software.

The original device should first be completely

uninstalled.

The program detected that your computer is not

configured for proper USB support. There are

four main conditions to check:
1. You do not have a USB connection on the

motherboard. The solution is to upgrade your

motherboard or add a USB controller card.
2. It is possible that you do have the proper OS,

but there is no connection between the

motherboard and the USB connectors on the

bracket.
3. It is possible that you do have the proper OS,

but the controller on the motherboard is

malfunctioning.

There are two main possibilities:
1. The host computer might be in standby mode,

and not supplying full power to its devices.
2. The Ethernet Adapter did not properly

enumerate. Enumerate is a USB term meaning

the system has identified and configured the

device and given it a unique address.

The Ethernet port connection might be

inoperable. Check the Ethernet connection.

Replace the Ethernet cable.

Consult the appropriate Windows

documentation, or contact your System

Administrator.

Remove and reinstall the USB support

component of the operating system.