Belkin USB Ethernet Adapter F5U011 - Manual (Page 11)

5. UNINSTALLING PROCEDURES
If you wish to remove the Belkin USB Ethernet Adapter component from your
computer, do the following:
1. Disconnect the USB cable from the adapter.
2. Select My Computer / Control Panel / Add/Remove Programs.
3. In the Install/Uninstall tab, select USB Ethernet Adapter.
4. Click Add/Remove.
5. Click Yes.
The software program will be automatically removed by Windows
® .
6. TROUBLESHOOTING
If you encounter difficulties when installing or using the Belkin USB Ethernet
Adapter, use the following table to troubleshoot the problem.
PROBLEM SUGGESTED SOLUTION / COMMENTS
You cannot find the other computer (on the
Ethernet side of the network connection).
When reconnecting the USB device, the
system seems to take a long time.
The system installation appears to be slow.
The Ethernet Adapter does not work when
connected through a bus-powered USB hub.
Use the Windows ® Find Computer option.
Be patient when reconnecting a USB device.
Wait at least 20 seconds between disconnecting
and connecting devices.
Be patient when Windows ® is installing the
Adapter (or any other USB device). Plug and
Play operations in Windows ® can sometimes
take up to 30 seconds or so between apparent
activities.
The Belkin USB Ethernet Adapter is a (USB)
bus-powered product. Current versions are
considered high power devices (that is, they
consume more than 100 mA when in operating
mode). Thus, they cannot be used downstream
of bus-powered hubs, which deliver only 100
mA per port. The adapter will enumerate
correctly, but the operating system will not
allow it to come up to full power.
8