Lenze DDS Global Drive PLC Developer Studio - Manual (Page 9)

Function library LenzeAifParMapDrv.lib
Introduction
2.1 General
2−1
L
LenzeAifParMapDrv.lib EN 1.1
2 Introduction
2.1 General
Lenze drive controllers and automation systems are parameterized via codes.
If a drive system is replaced by a PLC it might be necessary to adapt parameter access from a
higher−level control system to the new IEC61131 application, e.g. because some functions might
have to be parameterized via other codes than before.
The function library LenzeAifParMapDrv.lib includes functions which can be used to redirect
("map") codes via the AIF interface to other PLC codes for parameter access from a higher−level
control system.
2.2 AifParMap driver
The operating system (as of V6.0) of Lenze PLCs includes a specific AifParMap driver which can be
activated by using the functions of the function library LenzeAifParMapDrv.lib.
The driver can be used to redirect access to individual codes via the AIF interface to other PLC codes.
Note!
The function of the AifParMap driver is only available for the AIF interface.