Lenze p300 Mounting Instructions - Manual (Page 3)

MA_p300 DE/EN/FR/ES/IT 1.1
3
l
KFZ_Zeichen_EN−M−Install_WiHis_p300_en
¸
(
Stop!
Only carry out mounting/dismounting when no voltage is applied in order to
protect electronic components from damage.
,
Read this documentation and the operating instructions for the device before
you start working.
Documentation and tools around the Lenze products can be found in the
download area at
http://www.Lenze.com
ƒ Continuous and adequate air circulation is essential in the installation space so that
the device’s heat is correctly dissipated. Make sure that the ventilation slots are never
covered.
ƒ When choosing the installation location, ensure that the screen is in an
ergonomically suitable position and that light is unable to cause irritating reflections
on the screen.
ƒ During installation, there is a danger that the controller will fall out of the mounting
cutout. You should therefore secure it to prevent this happening until all screw
clamps have been fitted.
ƒ During mounting, the gasket of the front frame is exposed and can be damaged.
– Handle the gasket with care during mounting.
– Protect the gasket against ultraviolet rays.
– Check the gasket to make sure it is undamaged before you install the device.
ƒ The device must be securely seated in the mounting cutout and the front panel seal
must be correctly fitted. Otherwise, class of protection IP65 will not be achieved on
the front side of the device!