Deactivating call forwarding with a function key, Appendix, Care – Siemens Euroset 5020 User Manual
Page 9: If your telephone is not working perfectly, Insert strips, Contacts, Authorisation
euroset 5020 / IM eng-fra-russ-kro / A30350-M209-A801-2-UP19 / 5020.fm / 24.07.2006
9
GB
(b) Changeable call forwarding
o
;
Enter the phone number of the forwarded call
destination, press the last number redial key to
mark the end of the phone number entered.
You may hear an announcement that the
service is activated.
a
Replace the handset.
Incoming calls will be forwarded from now on
to the forwarded call destination. Your tele-
phone will not ring.
Saving "Deactivate call forwarding" on a function key
The call forwarding, as described in the previous example,
can be deactivated again with your network provider e.g.
with key sequence
#21#
.
You can save this key sequence on a dedicated repertory key
as well. If the symbol display is activated and the service is
activated as described, the
™
symbol in the display disap-
pears after the service is deactivated.
?=
Initiate function.
:
Press the repertory key that is designated for
symbol display "
™
off", see "Deactivating/acti-
vating the symbol display for additional serv-
#21#
Enter the select function for "Immediate call
forwarding".
?
Press the Set key.
Deactivating call forwarding with a function key
c=
Lift handset, press the Shift key.
:a
Press the repertory key for symbol display
"
™
off". Replace handset.
The
™
symbol disappears. You may hear an announcement
that the service is deactivated.
Appendix
Care
To clean, wipe with a moist or antistatic cloth only, never
with a dry cloth (risk of electrostatic charging and
discharge) or harsh cleaning agent.
If your telephone is not working perfectly
No signal tone: The tone volume might be set to 0.
Lift handset, no dialling tone: Is the connecting lead
correctly plugged into the telephone and the telephone
socket?
Dialling tone audible but telephone will not dial:
The connection is OK. Is the dialling mode set correctly
(see page 5)?
PABX only: No connection or incorrect connection when
dialling from memory (e.g. redial, speed dial):
Program external line prefixe.
The other party cannot hear you: Have you pressed the
Mute key? Press the key again. Is the plug from the handset
cord inserted correctly?
Recall key does not work: Set appropriate flash time.
The caller's phone number and the calls list are not
displayed:
Is the adapter connected (see page 2)?
Can Calling Line Identification be used (see page 6)?
Insert strips
Blank insert strips for the repertory keys can be found on the
Internet at http://www.siemens.com/euroset.
Contacts
If you should encounter any problems when operating the
telephone connected to a communication system with
analogue network access, please contact the network
operator responsible or your dealer.
Authorisation
This device is intended for analogue phone lines in your net-
work.
Country-specific requirements have been taken into consid-
eration.
We, Siemens Home and Office Communication Devices
GmbH & Co. KG, declare that this device meets the essential
requirements and other relevant regulations laid down in
Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of Conformity is availa-
ble at this Internet address: