Labnet Z400K High Capacity Centrifuge - Manual (Page 21)

Z 400 K / March 1997 21 E
Error no.: 22 Error no.: 22 Error no.: 22 Error no.: 22 Error no.: 22 Rotor is not mentioned in the rotor chart Rotor is not mentioned in the rotor chart Rotor is not mentioned in the rotor chart Rotor is not mentioned in the rotor chart Rotor is not mentioned in the rotor chart
Reason: Rotor is not authorized for this unit
Action: Insert only rotors authorized for this unit
Error no.: 25 Error no.: 25 Error no.: 25 Error no.: 25 Error no.: 25 Power failure Power failure Power failure Power failure Power failure
Reason: Power failure while rotor is in motion
Action: Open and reclose the lid, restart the centrifuge
Error no.: 30 Error no.: 30 Error no.: 30 Error no.: 30 Error no.: 30 Radius correction Radius correction Radius correction Radius correction Radius correction
Reason: Radius correction value too big
Action: Adjust the radius correction to the correct value
Error no.: 36 Error no.: 36 Error no.: 36 Error no.: 36 Error no.: 36 Relay for the frequency converter cannot be released Relay for the frequency converter cannot be released Relay for the frequency converter cannot be released Relay for the frequency converter cannot be released Relay for the frequency converter cannot be released
Reason: Defect on the power board
Action: Call service
Error no.:50,51 Error no.:50,51 Error no.:50,51 Error no.:50,51 Error no.:50,51 Memory failure Memory failure Memory failure Memory failure Memory failure
Reason: Internal or external memory failure
Action: Restart the unit, if the failure occurs again, call service
Error no.: 55 Error no.: 55 Error no.: 55 Error no.: 55 Error no.: 55 Overspeed Overspeed Overspeed Overspeed Overspeed
Reason: Overspeed sensor or engine speed sensor defective
Action: Call service
Error no.: 60 Error no.: 60 Error no.: 60 Error no.: 60 Error no.: 60 Engine speed sensor signal is missing Engine speed sensor signal is missing Engine speed sensor signal is missing Engine speed sensor signal is missing Engine speed sensor signal is missing
Reason: Engine speed sensor defective or parting of a cable at the sensor
Action: Call service