Kuryakyn 6241 UNIVERSAL ISO GRIPS - Manual (Page 3)

PAGE
3
STEP 9 Repeat Steps 7 and 8 for the throttle side. Do not use a spacer on this side!
ROTATE THROTTLE AND CHECK THAT IT MOVES FREELY AND RETURNS
TO CLOSED BEFORE STARTING BIKE. FAILURE OF THE THROTTLE TO
PROPERLY RETURN COULD RESULT IN LOSS OF CONTROL CAUSING
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
INSTALLATION OF THROTTLE SIDE GRIP FOR OPEN END THROTTLE TUBE
Use extreme care when using the glue included with this kit. Read all
precautions and avoid contact with skin or eyes.
Cover any area of the motorcycle where the glue could possibly drip during
installation.
STEP 10
Decide if you want the grip’s pads to match the clutch side when the bike is at rest or
underway with the throttle slightly opened. Without adhesive, slide the grip into place and
determine its position. Make a mental note of the location or make a non-permanent mark on
the grip and/or switch housing.
STEP 11
Remove the grip and give the throttle sleeve and inside of grip a quick wipe with an ammonia
based cleaner to ensure they are free of contaminates. Take the second supplied tube of adhesive
and apply a good amount of glue onto the throttle tube.
If your bike has an open end throttle sleeve, you must be very careful not to get
glue between the sleeve and the bar. This will permanently glue the bar to the
sleeve, leaving it inoperative.
NOTE:
Cutting a slit in a thin piece of cardboard, such as the back card from the grip package,
so that it can fit around the handlebar next to the switch housing, will help keep any
glue that is plowed up away from the housing when performing this next step. After
completing this next step, remove the cardboard.
STEP 12 Slide the grip into place, rotating it clockwise as you slide it on to help distribute the glue
evenly and keep the grip from “plowing” glue up against the switch housing. Be prepared to
quickly wipe away any excess glue being “plowed” up by the grip that could be forced up against
the switch housing. Once in place, squeeze the grip firmly to press the rubber against the bar and
hold for 15 seconds. Full bonding will occur in 24 hours.
ROTATE THROTTLE AND CHECK THAT IT MOVES FREELY AND RETURNS
TO CLOSED BEFORE STARTING BIKE. FAILURE OF THE THROTTLE TO
PROPERLY RETURN COULD RESULT IN LOSS OF CONTROL CAUSING
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will not
provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
UNIVERSAL ISO GRIPS
INSTALLATION