Kuryakyn 7640 BAHN LEFT-HAND IGNITION COVER for VICTORY - Manual (Page 3)

PAGE
3
STEP 6 Position the cover assembly on the ignition bracket . The three
studs will fit in the three slots in the ignition bracket. PIC 9 Attach
it to the ignition bracket from the backside with the three included
M6 nuts. PIC 10 Leave the nuts loose until all three have been
started and the cover is aligned with the ignition switch face, then
tighten the nuts.
Ride On!
BAHN LEFT-SIDE IGNITION COVER for VICTORY
INSTALLATION
PIC 9
IGNITION
SWITCH FACE
TIPS FOR PROPER CARE:
Your new BAHN product is made out of anodized aluminum. Anodized aluminum requires special at-
tention when cleaning. Some cleaning products or procedures can actually remove the anodized
treatment which will lead to pitting in the aluminum. Not cool.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and water. Regular cleaning
keeps contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product. Never use steel or brass
wool, wire brushes, polishing wheels, rubbing or polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN product. Many detergents are
alkaline based.
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.
Key chains and fobs coming in contact with the BAHN
cover will damage the anodized finish. PIC 10
IGNITION
SWITCH FACE