Kuryakyn 7640 BAHN LEFT-HAND IGNITION COVER for VICTORY - Manual (Page 2)

PAGE
2
NOTE: The BAHN Left Hand Ignition Cover for Victory can be mounted either
horizontally or vertically. Decide which way you want the cover to be
mounted before beginning the installation. PIC 1 and 2
STEP 2
Remove the OEM cover. Gently pull out on the edges of the cover to release the tabs from
the grommets. Set the cover aside, it will not be re-used.
STEP 3 Locate the Bracket in the hardware kit. Refer to PIC 3. Note that the orientation of the
bracket, whether mounted vertically or horizontally, is the same. PIC 4 and 5
STEP 4 Insert the three included M6 screws through the included External Tooth Lock
Washers and into the threaded holes as shown in PIC 6 and 7. Gently snug the
screws. DO NOT OVER TIGHTEN THE SCREWS!
STEP 5
Flip the bracket with the screws over and attach the mounting bracket to
the cover with the remaining three M6 screws. PIC 8 The bracket orienta-
tion and screw locations will be the same whether the cover is horizontal
or vertical.
-cont.-
BAHN LEFT-SIDE IGNITION COVER for VICTORY
INSTALLATION
Working around the sharp edges of the cylinder-head
fins exposes your hands to injury. Wear protective
gloves to prevent serious injury.
PIC 8
HORIZONTAL
ATTACH THE
BRACKET TO THE
COVER WITH
THREE SCREWS
PIC 1
VERTICAL FRONT
PIC 2
HORIZONTAL FRONT
TOP
PIC 3
TOP
TOP
HORIZONTAL VERTICAL
PIC 4 PIC 5
PIC 7
TOP
PIC 6
INSTALL THREE SCREWS WITH LOCK WASHERS
IN THREADED HOLES