Kuryakyn 7610 KINETIC MINI BOARDS with ADAPTER - Manual (Page 3)

PIC 3
5/16” SCREW AND
FLAT WASHER
VIEW OF UNDERSIDE OF BOARD
PAGE
3
ADJUST THE KINETIC MINI BOARDS:
NOTE: There are three splined mounting holes in the Boards. PIC 3 You may use
these to adjust the Boards forward or rearward and tilt them up or down.
STEP 6 Adjust the Board forward or rearward: Remove the 5/16” screw and washer from the under-
side of the Board. PIC 3 The Adapter will remain on the motorcycle.
Choose your location and orientation of the Board. Reinstall the 5/16” screw, with flat washer, in
the Board. Thread the screw into the Adapter.
Ensure the splines on the Board and Adapter are engaged and tighten the screw securely.
STEP 7
Adjust the Board angle: Loosen (but do not remove) the 5/16” screw. PIC 3 Adjust the angle to
the desired position. Ensure that the splines are engaged and retighten the screw.
STEP 8 Fold the board up and ensure that it does not contact any part of the bike. Adjust if necessary.
KINETIC MINI BOARDS with ADAPTER INSTALLATION
Ride On!
ENSURE THAT THE INSTALLATION OF THESE BOARDS DOES NOT
INTERFERE WITH THE PROPER OPERATION OF THE MOTORCYCLE
BEFORE RIDING. INTERFERENCE WITH THE CONTROLS OR ANY
COMPONENT ON THE MOTORCYCLE MAY CAUSE LOSS OF CONTROL
RESULTING IN SERIOUS INJURY OR DEATH.
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.