Ride on, Bahn lower fork accent for victory, Installation – Kuryakyn 7125 BAHN LOWER FORK ACCENT for VICTORY User Manual
Page 2
STEP 2
Using soap and water, clean the area shown in PIC 1 on both sides of the bike. Remove all grease,
bugs and road debris from the area. Wipe the areas down with the included alcohol pads and allow
to dry completely.
STEP 3
Position the Lower Fork Accent as shown in PIC 2. Ensure that the accent
is centered on the lower fork.
STEP 4
Use masking tape and a marker to make alignment marks on the lower
fork. PIC 3 Remove the Accent.
STEP 5
Rub the backing on the backside of the accent with your fingernail to acti-
vate the adhesive. PIC 4 Remove the backing.
STEP 6
Using the marks made in
STEP 4
, align the Accent on the lower fork.
Press it into place for one minute. Full bonding will occur after 24 hours.
STEP 7
Repeat
STEPS 3 through 6
for the other side.
NOTE:
If the bike is going to be operated before the full
bonding takes place, secure the accent to the fork
with a good quality masking tape or painter’s tape.
BAHN LOWER FORK ACCENT for VICTORY
INSTALLATION
Ride On!
TIPS FOR PROPER CARE:
Your new BAHN product is made out of anodized aluminum. Anodized aluminum
requires special attention when cleaning. Some cleaning products or pro-
cedures can actually remove the anodized treatment which will lead to
pitting in the aluminum.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and water.
Regular cleaning keeps contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product. Never use steel or brass wool, wire
brushes, polishing wheels, rubbing or polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN product. Many detergents are al-
kaline based.
PAGE
2
CLUTCH-SIDE (LEFT)
PIC 1
PIC 2
PIC 3
PIC 4
CLEAN
THIS AREA
ALIGN
MAKE ALIGNMENT MARKS WITH TAPE AND A MARKER
RUB THE BACKING TO ACTIVATE THE ADHESIVE