Kuryakyn 1676 LARGE TECH-CONNECT with PERCH MOUNT - Manual (Page 3)

PAGE
3
TO PREVENT POSSIBLE LOSS OF CONTROL, WHICH COULD
RESULT IN SERIOUS INJURY OR DEATH, WE DO NOT
RECOMMEND REMOVING, REPLACING OR OPERATING THE
DEVICE IN THE TECH-CONNECT WHILE RIDING THE
MOTORCYCLE .
USING THE TECH-CONNECT HOLDER
STEP 1 Open the Tech-Connect Holder so the sides are separated from the center
section. Peel the narrow pieces of foam off the backing paper, center them in the
inset portion of the sides and apply them to the sides of the holder. Peel the
wide piece of foam from the backing paper, center it in the inset portion in the
center and apply it to the center of the holder. PIC 6
STEP 2 To adjust the opening in the Tech-Connect larger, turn the knobs on the
outside of the Tech-Connect (PIC 6) counter clockwise until your device
will fit in between the arms. Turn the knobs clockwise to close the arms
around the device. There is a locking detent under the knobs to hold them
in place once they come in contact with the device. DO NOT over
tighten the knobs. Tightening them too tight will not allow you to
loosen them with your fingers. Periodically check the tightness of the
mobile device in the Tech-Connect.
NOTE:
For best results keep “L” shaped foot portion of the Tech-Connect
Holder on the bottom of the device. Keep the device holding
support arms centered on the mounting plate.
STEP 3 To remove the Tech-Connect from the bike for storage, loosen the tensioning
nut on the back side of the holder until it clears the threads. PIC 7 Snap the
Tech-Connect holder off of the ball. PIC 8 Remove the tension nut and thread it
to the Tech-Connect holder for storage.
STEP 4 To replace the Tech-Connect on the swivel ball, remove the tension nut from the
back. Slide the tension nut over the swivel ball, snap the Tech-Connect back on
the swivel ball and thread the tension nut onto the Tech-Connect. Tighten the
tension nut to the desired tension.
STEP 5 To adjust the angle of the Tech-Connect, loosen the tensioning nut, adjust the
Tech-Connect to the desired position and tighten the tension nut. PIC 7 The
tension nut will allow you to keep the Tech-Connect in the same position or, with
a little less tightness, allow you to move the Tech-Connect on the swivel ball.
DO NOT ATTEMPT TO OPERATE OR REMOVE THE MOBILE
DEVICE WHILE OPERATING THE MOTORCYCLE.
Ensure that the Mobile Device is secure in the Tech-Connect Holder.
Küryakyn is not responsible for any Device that is stolen or
damaged from use in this Holder or from the Holder not being
properly secured to the motorcycle. It is the installer’s
responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle.
Küryakyn will not provide warranty coverage on products or
components lost due to improper installation or lack of
maintenance. Periodic inspection and maintenance are required on
all fasteners.
Motorcycling can be done in a harsh environment. Make sure your
Mobile Device is appropriate for this application.
Ride On!
LARGE TECH-CONNECT
INSTALLATION
PIC 5
LINE UP HEX FLATS
PIC 7
USE 1/4” FLAT WASHER
FIRST, THEN 1/4” LOCK
WASHER, THEN ACORN
NUT HERE
USE TENSION NUT TO ADJUST HOLDER
PIC 8
TURN KNOBS
TO ADJUST
PIC 6
NARROW PIECES
OF FOAM GO HERE
WIDE PIECE OF
FOAM GOES HERE