Kuryakyn 1699 TECH-CONNECT DEVICE HOLDER for HANDLEBARS - Manual (Page 2)

PAGE
2
Avoid damage to the motorcycle. Protect painted surfaces
with a soft cloth or blanket.
STEP 2 Place a clean, soft blanket over the gas tank to protect the paint.
Ensure that the installation of this product does not
interfere with the proper operation of the
motorcycle before riding.
It is the installer’s responsibility to ensure that there is
adequate clearance between the Tech-Connect and any
painted surfaces. Küryakyn is not responsible for any
damage due to inadequate clearance.
Be aware of any cables/wires that could potentially be
pinched or crushed while using this product.
STEP 3 Determine the diameter of the bars, 7/8”, 1” or 1-1/4”, that are on the motorcycle.
The Tech-Connect Handlebar Mount includes reducers that allow it to fit these sizes.
Use the thicker set for 7/8” bars, the thinner set for 1” bars (these reducers are
marked with there size on the inside, PIC 2) and the clamp alone for 1-1/4” bars.
PIC 1 and PIC 2
Ensure that the supplied anti-seize is applied to all threaded fasteners
before installation; this will make future removal of the fasteners easier.
STEP 4 Using the correct clamp reducers (if needed-PIC 1), install the clamp to a straight
portion of the handlebars, in the desired location with two of the included
#8-32 X 3/4” Phillips Head Screws and #8-32 nylock nuts. PIC 3 Leave snug for now.
STEP 5 Install the Tech-Connect Holder to the handlebar mount by inserting the metal
shaft through the hole in the handlebar mount. The hex flats on the metal shaft
will line up with the hex flats in the hole. PIC 4 Secure the Tech-Connect with the
included 1/4” flat washer, then the 1/4” lock washer, then the Acorn nut. PIC 5
Tighten securely.
STEP 6 Turn the handlebars in both directions to their full stop position and ensure that
there is clearance between the Tech-Connect and the gas tank, dash and other
accessories. Adjust the clamp position if required. Tighten the #8-32 clamp screws
securely.
ENSURE THAT THERE IS CLEARANCE AT ALL POINTS WHEN
THE HANDLEBARS ARE TURNED, INSUFFICIENT CLEARANCE
MAY CAUSE DAMAGE TO THE MOTORCYCLE OR CAN CAUSE
LOSS OF CONTROL THAT COULD RESULT IN SEVERE INJURY
OR DEATH.
TO PREVENT POSSIBLE LOSS OF CONTROL, WHICH COULD
RESULT IN SERIOUS INJURY OR DEATH, WE DO NOT
RECOMMEND REMOVING, REPLACING OR OPERATING THE
DEVICE IN THE TECH-CONNECT WHILE RIDING THE
MOTORCYCLE.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the
motorcycle. Küryakyn will not issue a warranty on components lost
due to improper installation. Periodic maintenance may be required.
TECH-CONNECT DEVICE HOLDER
INSTALLATION
-cont.-
PIC 2
PIC 3
PIC 4
PIC 1
1-1/4” CLAMP HALF
7/8” REDUCERS
1” REDUCERS
1-1/4” CLAMP HALF
LINE UP HEX FLATS