Kuryakyn 1688 USB POWER PORT—UNIVERSAL - Manual (Page 3)

PAGE
3
Ensure the area of installation is free of grease, oil, dirt or other debris including
wax/polish products and bugs to ensure proper adhesion. Küryakyn WILL NOT
issue a warranty on any parts lost due to improper installation.
The adhesive will not bond correctly if applied at temperatures less than 50°F. Do
not attempt this installation in temperatures less than 50°F.
STEP 8 If using just the adhesive pad—Rub the backing of the adhesive tape with your fingernail to
activate it. Remove the backing and press tape to the underside of the Power Point for one
minute. Rub the backing of the adhesive now attached to the Power Point with your fingernail to
activate it. Remove the backing and press the Power Point to the desired location for one minute.
Full bonding will occur in 24 hours.
If using the handlebar mount—Rub the backing of the adhesive tape attached to the Handlebar
Mount with your fingernail to activate it. Remove the backing and press the Power Point/
Handlebar Mount to the desired location for one minute. Full bonding will occur in 24 hours.
NOTE: If the motorcycle is to be operated before the 24 hour cure time has expired, use a good
quality masking or painter’s tape over the Power Point to assist in holding it in place
until the cure time is over.
MOUNTING WITH THE SCREW PLATE
STEP 9
Determine the location for the Plate. Mark the location of the two holes to be drilled. Remove the
Power Point/Mount and, with a center punch, mark the center of each hole.
MEASURE TWICE – DRILL ONCE. Double check all reference marks made on the
fairing BEFORE drilling. Küryakyn will not be responsible for incidental or
consequential damages resulting from this installation.
STEP 10 Determine that nothing is beneath or behind the location of the holes will be damaged or
interfered with. Using a 1/8” drill bit, carefully drill the mounting holes.
STEP 11
Rub the backing of the adhesive tape on the Screw Plate with your fingernail to activate it.
Remove the backing. Using the included #6-32 X 3/8” Phillips screws, mount the Plate to the
location.
STEP 12 Replace the seat or side cover.
AFTER INSTALLING THE SEAT, PULL UP ON IT TO ENSURE IT
IS LOCKED INTO PLACE. A LOOSE SEAT CAN SHIFT AND
CAUSE LOSS OF CONTROL RESULTING IN SERIOUS INJURY
OR DEATH.
STEP 13
Use the fins on top of the Power Port to store the rubber plugs when using the
Power Port by pressing the retaining cord in between the fins. PIC 4
Ride On!
USB POWER PORT
INSTALLATION
PIC 4 PRESS RETAINING CORD
BETWEEN FINS