beautypg.com

Ride on, Ergo ii with iso wings, Installation – Kuryakyn 4057 ERGO II/6 ARMS with ISO WINGS User Manual

Page 3

background image

PAGE

3


STEP 9

Repeat Steps 2 through 8 for the right side.


ADJUSTING THE POSITION OF SWINGARM AND

ISO WINGS

STEP 10

Adjust for Longer or Shorter Inseam Lengths:

Loosen the 1/2-13 Button Head Fastener securing the swingarm to the

mount. Pull the swingarm out of the interlocking cogs.


Rotate the swing arm to the desired position then push the arm back

into the interlocking cogs; be sure the swingarm is either level with the

engine guard, or above the engine guard. NEVER position the

swingarm below the engine guard! FIG 1 Retighten the 1/2”-13

fastener.

IT IS THE INSTALLERS RESPONSIBILITY TO ENSURE

THERE IS SUFFICIENT CORNERING CLEARANCE
BEFORE RIDING. ALWAYS POSITION THE SWINGARM

EITHER LEVEL WITH, OR ABOVE THE ENGINE GUARD.

POSITIONING THE SWINGARM BELOW THE ENGINE

GUARD WILL GREATLY DECREASE CORNERING

CLEARANCE WHICH MAY CAUSE LOSS OF CONTROL

RESULTING IN SERIOUS INJURY OR DEATH.


STEP 11

Adjust the Clevis Angle:

Loosen the 1/2”-13 Hex Head fastener securing the swingarm to the

clevis. Pull outward on the clevis and ISO Wing to clear the roll pins.


Rotate the clevis and ISO Wing assembly to the desired angle then push

the assembly back into the swing arm, making sure the roll pins in the

clevis line up with the holes on the swingarm, and re-tighten the

fasteners. Install the black thread plug in the swingarm. PIC 5

STEP 12

Adjust the Peg Angle:

To assist in holding the ISO Wing in the desired position, there is a

setscrew on the side of the peg. PIC 4 Loosen the setscrew, then loosen

the peg adjustment fastener (PIC 5)and rotate the peg to the desired

position. Re-tighten the peg adjustment fastener, then tighten the

setscrew.


STEP 13

PIC 5 shows the complete assembly.


It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will not
provide warranty coverage on products or components lost due to improper

installation or lack of maintenance. Periodic inspection and maintenance are

required on all fasteners.



Ride On!

ERGO II with ISO WINGS

INSTALLATION

FIG 1

PIC 5

BLACK PLUG
GOES HERE

LOOSEN THIS FASTENER
TO ADJUST PEG

PIC 4

TIGHTEN SETSCREW
AFTER POSITIONING PEG